|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
| Heat Treating and Metallurgy Discussion of heat treatment and metallurgy in knife making. |
 |
|
|
Thread Tools | Display Modes |
|
#2
06-27-2013, 08:35 AM
|
||||
|
||||
|
You didn't give us much info to go on but I would suspect that possibly the foil pack got too close to an element and overheated.
Have you used foil from the same roll previously with no problems? Did the foil harden normally after cooling? If not, then the problem may be the foil but it's doubtful. If it hardened normally or if you have used foil from the same roll before with no problems then probably for some reason it was overheated. I would definitely H/T the blade again in any case. Gary __________________ Gary ABS,CKCA, ABKA,KGA Last edited by Gary Mulkey; 06-27-2013 at 09:10 AM. 
|
|
| Tags |
| blade, harden, knife |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rather than foil... | DaveL | Heat Treating and Metallurgy | 0 | 03-19-2012 02:59 PM |
| H/T foil??? | dbalfa | Heat Treating and Metallurgy | 16 | 03-30-2009 04:10 PM |
| S.S. Foil VS Coating | Teknition | Heat Treating and Metallurgy | 26 | 03-25-2008 01:52 PM |
| SS Foil | jose cuervo | Heat Treating and Metallurgy | 2 | 11-14-2007 03:28 PM |
| HT SS foil | pjelect | Heat Treating and Metallurgy | 9 | 06-30-2005 03:57 PM |
Linear Mode
