major problems with ddr3BL

[EdStreet]

I made a ddr3 bl for my brother and put the spring in it. About a week after he got it he called me up and sa## the safety failed and would not lock. Yesterday he brought it to me and I changed out all the internal parts with the same results. I then changed out the blade (serrated) with a standard blade and that fixed it. I then put his original parts back in with the standard blade and that to worked correctly. I have not compared the 2 blades s##e by s##e yet. My question is this, is there anything I can do to the blade to fix this?

Ed

[cwp]

Ed,

If I remember the design correctly from when I played around with it, the safety blocks the button from being depressed, thus releasing the button lock. I am having trouble seeing how the blade can effect that.

--Carl

[EdStreet]

I put a taller safety in and it does work correclty now but any damage to the safety will result in failures like this.

I d## find out more to, it was abusive testing he was doing with the unit and there was pressure put on the button. Guess this means I will need to fabricate a stainless safety.

Ed

[battlement]

I have also found that alignment of the liners can be important. If the two grooves in the liner that the safety button sl##e in are not lined up correctly or if the liners are not perpindicular to each other, that the plastic safety has a tendancy to bind. Also check to make sure that the scales on your knife are not impairing the travel of the safety. I also find that the amount of tension placed on the pivot screw and the thickness of the pivot spacers can change the proper functioning of the safety, especially if you are using stand offs instead of a backspine. So, therefor, if one blade is slightly thinner than the other, it could change whether or not the two liners are exactly perpindicular to each other. Try just barely knocking the sharp edge off of the safety groove cut outs on each liner, with a diamond file or fine grit wet or dry paper, especially helpful for smooth operation if you do construct a stainless button. Plastic, stainless or aluminum, that seems to keep the button from hanging up, and will keep the plastic buttons from getting a groove worn into them.

Dave Bowers
www.battlementknives.com