Custom Knives | Other Knives | General Items
New Posts | New PhotosAll Photos

Go Back   The Knife Network Forums : Knife Making Discussions > Custom Knife Discussion Boards > Tool Time

Tool Time Let's talk shop. Equipment, Tips & Tricks, Safety issues - Post it here.

Thread Tools Display Modes
Old 02-10-2016, 12:00 AM
Blackstone Blackstone is offline
Join Date: Nov 2010
Location: Columbia, Missouri
Posts: 3
Looking for 3-phase motor

I'm trying to locate a (cheap, of course) 10 horse 3-phase motor to make a rotary phase converter. Haven't had much luck so far, as everybody seems to have junked out their old motors. Any thoughts on suppliers?
Reply With Quote
Old 02-17-2016, 09:13 AM
Blackstone Blackstone is offline
Join Date: Nov 2010
Location: Columbia, Missouri
Posts: 3
Found a motor

Thanks for the numerous contacts from members regarding the motor. At this time I have located and procured just what I was looking for. Again, thanks.
Reply With Quote

make, motor

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
3 phase motor/ vfd / phase converter question stryder Tool Time 7 11-18-2006 01:33 AM
Electric motor phase info... Mike Krall Tool Time 11 10-14-2006 10:17 PM
3phase motor compared to single phase Bob Warner Tool Time 17 09-13-2006 04:41 PM
VFD & 3 Phase Motor vs DC Drive & DC Motor, Opinions on Each Set Up GHNorfleet Tool Time 5 08-16-2005 08:26 AM

All times are GMT -5. The time now is 09:36 PM.

Copyright © 2000
? CKK Industries, Inc. ? All Rights Reserved
Powered by ...

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
The Knife Network : All Rights Reserved