|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cold working brass and a question about carbid burs
hi all
I was wondering, can I cold work smaller brass sections or do i need to heat it up? The section size is about 0.25" x 0.25" I need to twist it and bend it a bit. When using carbid burs, do i go with high or low rpm? |
Tags |
a, art, bend, bent, brass, ca, carving, cold, cutting, heat, knife, knives, made, make, makers, metal, pine, project, question, simple, small, steel, surface, wood, wrench |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
brazing brass bolster (question) | esa | Heat Treating and Metallurgy | 5 | 10-23-2005 08:43 AM |
brazing brass bolster (question) | esa | Knife Making Discussions | 0 | 10-14-2005 11:09 PM |
cold working | Coutel | Heat Treating and Metallurgy | 4 | 07-04-2005 08:10 AM |
Cold Shut Question | Greg Covington | The Damascus Forum | 4 | 03-10-2005 03:53 AM |
Working brass or nickle silver?? | MixonKnives | The Newbies Arena | 2 | 12-06-2004 01:52 AM |