View Single Post
  #2  
Old 07-02-2021, 02:20 PM
jimmontg jimmontg is offline
Guru
 
Join Date: Jan 2016
Location: Now live in Las Cruces NM.
Posts: 1,345
There's the old standby of fingernail polish.

Use electrical tape and tape off around the brand and cover evenly with fingernail polish and cut out the design with an E-xacto knife then gently scrape the cut out area off. It is the method I used rather than just scraping off the design and getting uneven edges because the polish doesn't come off precisely. By cutting the edges I get a nice edge, but it is for simple patterns unless you're really good at drawing.

You can also try cutting out the brand on Mylar and tape that onto the blade.
Reply With Quote