View Single Post
  #2  
Old 01-14-2004, 08:48 PM
polarbearforge's Avatar
polarbearforge polarbearforge is offline
Steel Addict
 
Join Date: Jun 2002
Location: Parker SD
Posts: 144
Nope, they all look like they don't have enough output torque. I didn't see any listing on the first one, but I doubt it has enough.

If you're using a gear reducer for the mill, look for at least 2000 inch pounds of torque. Anything less will leave you frustrated.

Jamie


__________________
Jamie Boley
Polar Bear Forge - Custom Blades
www.polarbearforge.com
jamie@polarbearforge.com
Reply With Quote