View Single Post
  #3  
Old 05-06-2021, 04:19 PM
KenH KenH is offline
Enthusiast
 
Join Date: Dec 2012
Location: South Baldwin Co across the bay from Mobile, AL
Posts: 70
Thanks Ed, that's exactly the type of info most folks like me are looking for. I've been working a set of squaring dies today and almost got them complete. Let me get out there and finish them. I'll move the press out, put top set of dies in, then lower gently to make sure the bottom set lines up exactly before tack welding in place. That's the only way I know to be sure they'll match.

Ken H>
Reply With Quote