Thread: Anvil stump
View Single Post
Old 04-11-2021, 07:32 PM
squigly1965's Avatar
squigly1965 squigly1965 is offline
Steel Addict
Join Date: Jan 2010
Location: Modesto, CA
Posts: 257
I’m using 1/2” allthread.
It will be a 3x2 pattern. Each way equaling roughly 11”. I’ll make 2 stacks of them on the 4” side squeeze together each stack with 2 pieces of allthread. Then squeeze the 2 stacks through each of the 6” widths using 6 more pieces of allthread.
Was wondering about doweling and gluing. Or will the allthread apply enough pressure for it to act as a single piece
Reply With Quote