View Single Post
  #1  
Old 07-24-2017, 09:59 PM
Greyfox76 Greyfox76 is offline
 
Join Date: Mar 2017
Location: Ardmore Oklahoma
Posts: 5
Duct work/Exhaust fan

I'm finally getting ready to move into a shop. I still run a coal burning forge, and have some questions about exhaust systems. The main problem that I'm running into is that I cannot find a 4-6 inch exhaust fan that can handle the temperatures that are produced. I was going to place the fan close to end of duct work approx 4 feet from opening above the forge, canopy approx 24-36 inche's above fire pit. Does anyone have any tips that I may be able to use in order to make this happen. I do plan on getting a gas forge in the future, but wanted to start off by using coal.
Reply With Quote