View Single Post
  #2  
Old 04-15-2021, 05:01 AM
Crex's Avatar
Crex Crex is offline
Moderator
 
Join Date: Sep 2002
Location: Acworth, GA and/or Hanging Dog, NC
Posts: 3,529
Actually that doesn't look too bad. Was the setting around 400? A lot will depend on the steel you used. If it's a "stainless" steel, can make a big diff. Hi-carb forgable should be ok.
Sharpen and try it out for edge retention and flex (before mounting a handle).


__________________
Carl Rechsteiner, Bladesmith
Georgia Custom Knifemakers Guild, Charter Member
Knifemakers Guild, voting member
Registered Master Artist - GA Council for the Arts
C Rex Custom Knives

Blade Show Table 5-J
Reply With Quote