View Single Post
  #6  
Old 05-24-2021, 03:19 PM
Chris Railey Chris Railey is offline
Enthusiast
 
Join Date: May 2021
Location: Waynesboro, Georgia
Posts: 60
Ed has the best way I have ever used for high layer count billets. Step one, over etch the blade in acid. Until you can "feel the topography" of the layers. Step two, spray with satin black Gun Kote and bake. Step three, use a flat piece of something and 1200-1500 grit paper to carefully sand away the black on the shiny layers which will be slightly higher. Step four, coat the blade in flat clear gun kote and bake. Its the best contrast I have ever gotten on a blade. I am currently trying it on a 30 layer billet I made an EDC from this weekend. Ed said it does not work well on low layer counts but I figured I would try.
Reply With Quote