View Single Post
Old 04-29-2021, 08:38 AM
Ed Caffrey's Avatar
Ed Caffrey Ed Caffrey is offline
Super Moderator
Join Date: Jun 2002
Location: Great Falls, Montana, USA
Posts: 4,329
Send a message via AIM to Ed Caffrey Send a message via Yahoo to Ed Caffrey
Likely the reason you don't find much via internet searching, is because a ribbon burner in a vertical forge is WAY overkill in terms of time/materials/complexity, and cost to operate.

Not saying it not doable/useful, its just that most prefer/do go the route of a single, correctly sized blown burner. It's just all round simpler/easier to build, takes less time to assemble install, and uses far less fuel in a vertical forge application.


"Nobody cares what you know.....until they know you care."
Reply With Quote