The Knife Network Forums : Knife Making Discussions

The Knife Network Forums : Knife Making Discussions (http://www.knifenetwork.com/forum/index.php)
-   Ed Caffrey's Workshop (http://www.knifenetwork.com/forum/forumdisplay.php?f=10)
-   -   How to wire/control two motors to one VFD (http://www.knifenetwork.com/forum/showthread.php?t=69480)

Ed Caffrey 04-16-2021 04:42 PM

How to wire/control two motors to one VFD
 
There are a lot of cautions and warnings in this article! FIRST: I am not responsible if you destroy something attempting this modification!
**I highly recommend using the EXACT same MODEL/HP motors. I suspect if you don't, you're likely going to destroy/burn up something.

**I know this works with KBAC VFDs.... I would not recommend trying it with any of the el-cheapo VFDs! You'll likely end up in a Blaze of Glory.....literally!

http://www.caffreyknives.net/1_vfd_2_motors.html


All times are GMT -5. The time now is 12:15 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
The Knife Network : All Rights Reserved