Custom Knives | Other Knives | General Items
New Posts | New PhotosAll Photos

Go Back   The Knife Network Forums : Knife Making Discussions > Gary Roberts

Conversation Between Gary Roberts and jellyroll
Showing Visitor Messages 1 to 1 of 1
  1. jellyroll
    01-13-2015 09:59 PM
    Hey Gary,
    Looked we had a bad connection on the phone today and thanks for trying to call. I wasn't sure if you got my email address, but try me at
    I tried laying it flat tonight and I still don't think it works well. I put a nice edge on it from my Arkansas translucent stone and then tried lightly and slowly stropping it flat on the strop. After 2 passes I checked it and I know it wasn't better and perhaps slightly (very slightly) less sharp, so I decided to stop (at least it will cut at this point). Now I can tell I have a noticeable burr, but I am curious if its possible to run the knife backwards on the stone to rid the burr instead of using my strop? I've never done that before and not sure if its even a good move.


All times are GMT -5. The time now is 10:22 PM.

Copyright © 2000
? CKK Industries, Inc. ? All Rights Reserved
Powered by ...

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
The Knife Network : All Rights Reserved