Cold rolled steel, bed frames

Well since we're being politically correct, I no longer care to be referred to as a "hillbilly." I'm an Appalachian American. :cool:

You can take us out of the mountains, but....

Lamnia Artifex
CKD Elite Member
Posts: 77
(4/19/02 3:24:31 pm)
Reply Re: homeschool or keeping in touch.
--------------------------------------------------------------------------------
As Tai says "I broke the rules but didn't get caught" hehe, same here man. And for the most part it's same for most of my peers. Teachers just don't care enough in my school, (those that I have had contact with) to discipline children, or seek out underlying problems.


Uh, Lamnia , what's your folks phone # :rollin:

I wouldn't actually tell them, but i might ask them if they know

Hehe, that's just it. Nobody knows what I did. There's not even something they could pin on me. I am too smart, : muwahahahaha :evil: And I have some interesting things to do with people who want my phone #.
"Hello, who is this? And how did you get this number?" Hehe, quote from operator at a bomb shelter for the higher-ups in our govt. Not my personal experience, but with a little ingenuity I can have you calling something fun. Good thing I'm not like that, not like someone who gives out numbers that is...

I Know. Lamnia. buhwahahahahah.......

I received this e-mail from someone who had trouble logging on. Any comments?

HI DANA
I WAS READING THE FORUM TOPIC ON BEDFRAME STEEL .. IN JERSEY SHORE ,PA. IS A COMPANY CALLED "JERSEY SHORE STEEL" . THEY MAKE A LARGE PERCENTAGE OF THE BEDFRAME RAIL USED
BY THE FURNITURE INDUSTRY. THIS IS HOT ROLLED
FROM RAILROAD RAIL. WHAT IS RAILROAD RAIL ???
I.VE FORGED SOME KNIVES FROM IT THAT ACT LIKE
A 1060.. MEERLY A GUESS ON MY SIDE..
THANKS
JEFF

Mr. & Mrs. Menghini
27093 Jarvis Rd
Bonita Springs , FL
(941) 498-0407

Assume Nothing.

AHAHAHAHAHAHAHA! My parents are what we common people refer to as insane. They "know" what I've done, so I've got nothing to hide. Right? Assume nothing. Right back at ya, you two. : :evil:

Hmmm. thought this thread was over didn't you

I cut up some t-bar from a salvaged garage door opener last night. I was using it on my postvise stand. The stuff sparkled and popped like old buzz saw blades.

I quench tested a piece and yes, it is hardenable.

T-bar , ought to make interesting knives, eh

Double wadd stock tacos - take low carbon wadd and shove it into the angles, then close the t bar down to the center bar, which will provide the cutting edge. Ohhhh! I like it!

I knew that would get somebody thinking