|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
| The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
|
Thread Tools | Display Modes |
|
#16
04-19-2017, 06:30 AM
|
||||
|
||||
|
Hammer control is whole separate issue and is subjective to your personal skills, available tools, and again the ugly head that rises......heat control. Lot of factors involved, but something that can be discussed/covered well in less than an hour at the forge. Then it takes concentrated focus in application to train muscles to do what the mind says the eyes see. Just too much to text-out here.
__________________ Carl Rechsteiner, Bladesmith Georgia Custom Knifemakers Guild, Charter Member Knifemakers Guild, voting member Registered Master Artist - GA Council for the Arts C Rex Custom Knives Blade Show Table 6-H 
|
| Tags |
| 1084, 440c, art, bee, blade, edge, file, forge, forging, handle, harden, heat, heat treat, how to, knife, knives, make, materials, newbie, pen, quenched, simple, steel, usa, water |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ordering steel | NJStricker | The Newbies Arena | 6 | 01-18-2006 08:41 AM |
| Ordering Steel? | AKmik | Knife Making Discussions | 11 | 11-13-2003 08:45 AM |
Threaded Mode