|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
need help with my burner
Ok maybe I set something up wrong but I built my forge its great but for some reason i cant get my burner to heat it like it should it gets warm but gets nowhere near hot enought I'll try and get pics of my setup on here in the light of day but i worked on building this setup for about three month and then this burner didnt work. I'm stuck and have no clue how to go about dealing with uping the heat
Any help would be much appreciated thanks |
#2
|
||||
|
||||
Since there are no pictures or even a description of what type of burner you built, this is the best advice I can give you at this point:
http://www.knifenetwork.com/forum/sh...ad.php?t=63917 |
#3
|
|||
|
|||
pics?
well I was going to post some pics but seem to be having some trouble figuring out how to add pics
Last edited by BigCountry; 10-01-2015 at 05:17 PM. Reason: screwed up the words |
#4
|
||||
|
||||
You'll need to participate in the forum for a while before the system will allow you to post pictures. Its a security thing to avoid spammers ...
|
#5
|
|||
|
|||
Ok then i think i rigged up a modified venturni burner i think i got the kink I had worked out I am going to try it again next day off. thanks for ya'lls help
KEEP HAMMERING, KEEP CUTTING |
#6
|
||||
|
||||
Clamp your torch in a vise pointing in a safe direction, set flare in place, pressure feed low, then light her up. You should get a nice forceful cone shape blue flame - See pic CC posted on other thread here - excellent example of what you should be getting.
If not you need to start adjusting things - ONE AT A TIME - start with available air Torch should perform like a mini jet engine. tweak until you get there, then reinsert into forge and fine tune. __________________ Carl Rechsteiner, Bladesmith Georgia Custom Knifemakers Guild, Charter Member Knifemakers Guild, voting member Registered Master Artist - GA Council for the Arts C Rex Custom Knives Blade Show Table 6-H |
Tags |
advice, art, building, burner, forge, heat, hot, how to, knife, post, show, vise |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Burner set up? whats Yours? | dtec1 | The Newbies Arena | 9 | 09-29-2015 10:30 PM |
burner help! | tomh | Ed Caffrey's Workshop | 16 | 01-26-2009 08:35 AM |
burner | Larry Harley | The Outpost | 19 | 04-11-2007 05:18 PM |
Your thoughts on a DVD burner?? | Ed Caffrey | Feature & Member Support | 6 | 11-29-2004 03:56 PM |
T-Rex burner | longhair51 | The Newbies Arena | 4 | 03-08-2004 04:47 AM |