|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
| Knife Making Discussions A place to discuss issues related to all aspects of the custom knifemaking community. |
 |
|
|
Thread Tools | Display Modes |
|
#1
07-14-2008, 03:15 PM
|
|||
|
|||
DIY 2x72 Belt Grinder Video
OK,
the HMG New Jersey Mark II in all it's glory. Even if you already have a tooling-arm-design grinder, such as Bader or KMG, take a look at it, I have some good ideas in there. Viddler is like youtube but just a bit friendlier to uploaders - with 500MB no-time limit, progress indicators . http://www.viddler.com/explore/Rashid11/videos/1/ Edit/Delete Message 
|
|
#2
07-14-2008, 09:45 PM
|
||||
|
||||
|
Very cool! You have a nice grinder there!
__________________ Andy Garrett https://www.facebook.com/GarrettKnives?ref=hl Charter Member - Kansas Custom Knifemaker's Association www.kansasknives.org "Drawing your knife from its sheath and using it in the presence of others should be an event complete with oos, ahhs, and questions."
|
|
#3
07-14-2008, 11:56 PM
|
|||
|
|||
|
Way cool!!!
Doug Lester __________________ If you're not making mistakes then you're not trying hard enough
|
|
#4
07-19-2008, 09:55 PM
|
|||
|
|||
|
I watched that the other day, your a pretty smart feller.
One comment on your grinder work arm: Why not use the same split hole arrangement for the work arm joints and use a bent over bolt for a handle. It would eliminate the need for a wrench and eliminate the arm loosening up because of the right hand thread issue you pointed out? Just a suggestion, you did an excellent job on that thing. I'll be building your heat treat box here very soon, I had a relay and a PID controller laying around and found fire bricks down here for $1.30 each. Excellent ideas. Danny
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
