|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Heat Treating and Metallurgy Discussion of heat treatment and metallurgy in knife making. |
|
|
Thread Tools | Display Modes |
|
#1
08-18-2017, 03:26 AM
|
|||
|
|||
|
Colouring the knife by tempering
Hi all
I was wondering if it is possible to colourise your blade by tempering? After finishing HT I rather quickly temper the blade before doing the finial finish. Is it possible to "re temper" after you have done all finish and after the initial temperingcycle to reach something like a light straw colour on the blade for final finish? I guess it would require a thorough cleaning to make sure no residues is on the blade. This is just a general question, but for the currentblade i'm speaking of, the steel is 80CRV2. Hope you can help me out :-) Rasmus 
|
| Tags |
| blade, blades, carbon, clean, cleaning, common, conversion, degrees, file, heat, hobby, hot, knife, knives, make, making, man, problem, question, show, steel, surface, temper |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| heat colouring Ti. | Trenton Entwistle | Knife Making Discussions | 2 | 05-08-2005 12:58 PM |
| Tempering Help | D.Gary Milne | Knife Making Discussions | 2 | 04-24-2005 09:12 PM |
| Background colouring | george tichbour | Fine Embellishment | 2 | 07-22-2002 08:26 PM |
| Pocket Knife Spring Tempering | Gene Chapman | The Outpost | 5 | 07-18-2002 02:36 PM |
Threaded Mode