|
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Bench Grinder Attachment
Does anyone have any experience/opinions on the attachments that turn one side of you bench grinder into a small belt grinder? Appreciate any input of a friendly nature.
|
#2
|
||||
|
||||
Here is a site for those. I have not used any of these, but, IMO, they would certainly be better than some alternatives I have seen discussed.
http://www.vansantent.com/multitool.htm __________________ Mike |
#3
|
|||
|
|||
I was lucky enough to pick up a 2x36 cheap the week after my 4x36" died. MUCH BETTER I've added a hi-temp glass platen to it.
It grinds well, tracks pretty good, contact wheel is usable and the disk is fair. At $180 plus the cost of a grinder you could get a Grizzly for another $100. Belts have to be special ordered or a 4x36 cut in half (which I do). My opinion? Not bad, but for $100 extra you could get a 2x72. Will |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|