|
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
Knife Making Discussions A place to discuss issues related to all aspects of the custom knifemaking community. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
thickness behind the edge question
Hi Guys, I am currently attempting to make a sort of Bob Loveless type knife, the classic one that he is probably best known for.
I cannot find the spec of the thickness the edge should be before you put the cutting edge on. Even just generally I am never sure what the edge should be. I have been told that a working knife should be around 0.020" to 0.030" and I have been told 0.010" or even thinner. To me 0.010" is thin for a working knife. Can you folks share some personal experience? I have made some carving knives but never a real working knife for the field so some advice from guys that have made those will be very welcome. the steel is A2 and also CM154. Thanks |
#2
|
||||
|
||||
In the case of a drop point, hunter the .015"-.03" range will yield a field usable blade to cover a w##e range of uses well. I've done them from .012"-.020" as the typical goal yet some have been a bit thinner.
A symmetrical cutting edge bevel in the 15-19 degrees range will yield a sharp blade for the usual tasks. A2 and CM 154 is a good choice. Keep us posted on your progress. __________________ Mike |
#3
|
|||
|
|||
Hi Mike,
Thanks for your tips. I will let you know how it goes. I sort of finished grinding one blade but I messed up the grind a bit on the front curve of the blade so I had to grind a couple of mm off to get r## of that. So of course, the whole shape and appearance has changed but I figure I will be okay with sacrificing it to experience. Once the HT is done I will be less than gentle with it and find out first hand how much punishment it can take without going completely cavemen on it. Thanks again. Mike |
#4
|
||||
|
||||
A good heat treat is a big factor. Knives are fairly tolerable of varying specs even when abused so you have some latitude to work with. Being as precise as possible does yield a higher quality product for users when the whole package is cons##ered.
My current batch of knives the edge bevel varies between them and that is expected for handmade products. __________________ Mike |
#5
|
|||
|
|||
Thanks Mike, you have given me some good information. Much appreciated.
Mike |
Tags |
advice, bee, bevel, blade, bob loveless, ca, carving, classic, cutting, edge, heat treat, hunter, knife, knives, loveless, made, make, question, sharp, steel, thickness, thin, tips |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Top Edge Thickness? | TWITHERS | The S.R. "Steve" Johnson Forum | 8 | 05-14-2015 01:30 PM |
What is best edge thickness before HT on 3/16 O-1 | Orion | The Newbies Arena | 3 | 07-27-2013 07:16 AM |
Edge Thickness | Doug Adams | Georgia Knifemaker's Guild | 2 | 11-16-2009 04:12 PM |
Edge Thickness | SHostetler | The Newbies Arena | 4 | 05-25-2008 12:15 PM |
Edge Thickness | Phantom23 | The Newbies Arena | 5 | 10-09-2003 07:53 AM |