|
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
Heat Treating and Metallurgy Discussion of heat treatment and metallurgy in knife making. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
A2, temper ideas
A2 is quite likely my favorite steel. I am curious about the temper used by others and wanted to see if anyone had developed a new high, low or what to temper A2.
|
#2
|
||||
|
||||
A2 is good for plate quenching from 1750 F .400-500 F is good for tempering that will give good toughness and about 60-61 HRc. No magic that I know.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|