Available shop equipment

I have to make some room in my shop, so the following items are for sale:

Craftsman 6x48 belt/disk sander (9? disk), all cast iron, with stand - $100
Atlas horizontal mill (model MF), with stand and some tooling - $500
Milwaukee die filer with an assortment of files - $200
Craftsman 1x42 belt/disk sander (6?disk) - $60

Here?s the rub- unless you want to pay for labor to haul it up the stairs and crate it for shipping, you have to come get it (Detroit area). Bring help. If someone wants the whole lot, you can have it for $750.

Don Cowles

Sounds like a good deal Don! There was a time I would have snapped it up!
but:
I am retiring from a long career in knife and sword making. The main piece of equipment that needs to move out of here is the heat-treat furnace. I have a custom built electric furnace for swords for sale. It's heavy (500lb), you'd have to pick it up.(Arkansas) I can help load (overhead trusses, w/block and tackle). 40 inches deep inside, 5" inside diam. 65 ampere draw at 220 Volt AC. Automatic set-point controller with anticipating circuit. Argon gas feed line. Sealable enclosure. Reaches 1900 degrees F soak in 45 minutes. $1450
Tom Maringer
maringer@arkansas.net

Drooolll...maringer....


Hey, Tom. you wouldn't happen to have any Vorpal templates laying around the shop floor, would you

Don,
still have that mill available? I know someone who might be interested. Could you send me a pic/more info?

Peace

Paul

Mill is still available- remember, any taker has to come and get it or pay to have it taken out. I'll take a pic tonite.

Here are the promised pics of the Atlas horizontal mill.

Once again, I don't know what the problem is, and I don't have time to mess with it now. More later.

When in doubt, check case and spelling first.

Alex

Nice Mill Don. My friend says he wants a vertical mill

Thanks anyway

Thanks, Alex.

Don, I'd love to get the mill but I don't know how to get it here. Do you know the weight?

Peter- With the stand it is probably between 5-600 Lbs.

Thanks anyway Dom...(Groan). I just can't get it here.