|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| The North Carolina Custom Knifemakers Guild Forum The North Carolina Custom Knifemakers Guild. Raising the general awareness of custom knives and the people who make them. |
 |
|
|
Thread Tools | Display Modes |
|
#1
04-19-2009, 05:16 PM
|
|||
|
|||
|
New Knifemaker Question
Hi, I am just getting back into knifemaking. I havn't made any knives in about 8 years now but I am slowly trying to get started again. Right now i am trying to find someone to heat treat my blades. I am looking for someone that does small quanties, 1-5 blades at a time. Right now i am using mostly 440C and some D-2. Thanks for helping.
|
|
#3
04-20-2009, 07:36 AM
|
|||
|
|||
|
Texas Knife Supply will do small batches for not too much money.
__________________ Cap Hayes See my knives @ knives.caphayes.com This quote pains me: -- "Strategically placed blood grooves control blood spray in covert deanimation activities." --
|
|
| Tags |
| knife, knives |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
