|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Here's a another one.
I ground this one out today. This one is 1095 with filework. I think I'm going to try to edge quench this one, so any info on edge quenching would be appreciated.
|
#2
|
|||
|
|||
Here's the hamon I got on the 1095.
|
#3
|
|||
|
|||
|
#4
|
|||
|
|||
Thanks, the steel is 1095 and I used satinite to get the hamon.
|
#5
|
||||
|
||||
Kevin, why did you etch your logo before doing the HT? If you wait until the blade is finished you'll get a much nicer looking mark ...
|
#6
|
|||
|
|||
Cuz I'm a rookie.
|
Tags |
1095, acb, blade, edge, etch, filework, hamon, heat, knife, steel |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|