Dragons Teeth some exotic push knives

[Kenhills]

Hi All,

Ok, so I call them Dragons Teeth, I made them so I can call them what I want. (Suggestions are always appreciated, though I reserve the right to use them.) So?????..Both are made from Aldo?s 3/16ths 1095 and hardened to about a 59-60 on the Rockwell scale. Both come with a Kydex belt sheath and both are hair popping sharp.

The Specifics: In the top picture, the one on top, the redder of the two.
Steel: 3/16ths 1095 to a Rockwell 59-60
Grind: Hollow on a 10 inch wheel
Length: A tad under 5 inches
Cutting edge: 2 7/8 inches
Length from the tip to the front of the scale: 4 inches
Height: 3.25 inches
Handle width: 5/8ths of an inch, snug and comfortable in the hand.
Scales: Bloodwood with 2 3/16ths brass pins
File work: Vine and thorns pattern along the spine.
Price shipped to the lower 48 with a Kydex sheath $90.00


The Specifics: In the top picture, the one on the bottom, the browner of the two.
Steel: 3/16ths 1095 to a Rockwell 59-60
Grind: Hollow on a 10 inch wheel
Length: A tad under 5 inches
Cutting edge: 3 inches
Length from the tip to the front of the scale: 4 inches
Height: 3.25 inches
Handle width: 5/8ths of an inch, snug and comfortable in the hand. A little more rounded than the top one.
Scales: Sapele with 2 3/16ths brass pins
File work: None
Price shipped to the lower 48 with a Kydex sheath $80.00

Comments are always welcome. Thanks for looking, Ken





















Tell me what you think! A lot of work goes into these, feedback would be great.