MEMBER ITEMS FOR SALE
Custom Knives | Other Knives | General Items
-------------------------------------------
New Posts | New PhotosAll Photos



Go Back   The Knife Network Forums : Knife Making Discussions > Custom Knife Discussion Boards > Knife Making Discussions > The Newbies Arena

The Newbies Arena Are you new to knife making? Here is all the help you will need.

Reply
 
Thread Tools Display Modes
  #1  
Old 09-24-2001, 10:34 PM
Gary Hamilton
Guest
 
Posts: n/a
D/C motor


Hello All,

I am new to this site. I make a UGLY knife worthy of only the dirtest scrap barrel and have plenty of questions.

I am sure this has been covered a million times on this site but I could not find any mention in the earlier messages. I am looking for a variable speed D/C motor to make a small grinder. I have heard that there are some 2-1/2 HP that are rather cheap but I did not have an address to go with the information. Does anyone have a source for this type of motor?

Thanks,

Gary
Reply With Quote
  #2  
Old 09-25-2001, 06:23 AM
KandSKNIVES
Guest
 
Posts: n/a

Here ar a few to start you off;
www.dealerselectric.com
www.roysstore.com/
groban.mfg@att.net
These are computer frienly and have some great pricing.
KEN (WWJD)
Reply With Quote
  #3  
Old 09-25-2001, 11:08 AM
Bill Foote
Guest
 
Posts: n/a

Here's a thread on a cheap 2.5HP. I ordered one and they are much smaller than one would expect. It is "treadmill duty".I plan on making a disk sander with it.
pub42.ezboard.com/fcustomknifedirectoryforumfrm14.showMessage?topicI D=104.topic


Reply With Quote
  #4  
Old 09-26-2001, 08:33 PM
Gary Hamilton
Guest
 
Posts: n/a
Thanks!


Thank you both for the info. Now I need to go look up this information.
Reply With Quote
Reply

Tags
knife


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

(View-All Members who have read this thread : 1
warren
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -5. The time now is 02:35 PM.




KNIFENETWORK.COM
Copyright © 2000
? CKK Industries, Inc. ? All Rights Reserved
Powered by ...

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
The Knife Network : All Rights Reserved