|
|
Heat Treating and Metallurgy Discussion of heat treatment and metallurgy in knife making. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Programming aberins 2352P PID
Just finished building our heat treat oven and now have to program the PID. Has anyone ever made a video on how to program the 2352P PID ? My daughter and I have spent many hours reading the manual and we still can't figure it out. We are going to be using 1084 and 1095 for a while before trying any of the stainless steels. Thanks for any and all the help and have a great day.
Gary & Tiffany |
#2
|
|||
|
|||
I don't know of a video, but I have one myself and it is pretty simple after you get the concept. The confusing part is because it ramps to the next step so you are not just setting the time, you are setting the time it takes to ramp to the next temp. Here is an example:
Step 1: temp=70 (starting temp) time= 30 (time it will take to get to the next step) Step 2: temp=1200 time=20 Step 3: temp=1200 (because I want it to stabilize at 1200 for 20 min see step 2) time=30 Step 4: temp=1800 time=35 Step 5: temp=1800(because I want it to stabilize at 1800 for 35 min see step 4) time= -121 (-121 is the command to stop) The first time it took me a bit to understand it. just remember it is a ramping controller so the time is to the next step's temp. It will calculate the temp vs time to evenly ramp the temp to the next step. |
#3
|
|||
|
|||
Thanks for reply and it did make it easier for us
|
Tags |
1084, 1095, building, comma, heat, heat treat, how to, made, make, simple, stainless, video |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|