|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
My third knife ironwood and g-10
Here are a couple of mediocre pics of my third knife. The blade is flat ground on my state of the art Grizzly 1" x 30" grinder. O-1 tool steel...3/16" X 1 1/2". It is 4 1/8" long, overall length is 8 1/8". The handle is made of desert ironwood with black G-10 bolsters, brass 1/8th" pins and the spacer material is the result of a poor fit between the handle and bolster material. I wound up with gaps and had no actual spacer material so not wanting to wait for spacer material to be shipped yadda yadda yadda I improvised and ground down some hacksaw blade, coated it with superglue gel, and tapped it into the gap :confused: and peened it in to fill the gap. Turned out looking pretty decent. Heat treated to non-magnetic then quenched and tempered in oven @ 400 for 1 hr. holds nice edge and I like the look of this one.
Last edited by JUNGIANEINSTEIN; 05-01-2005 at 06:38 AM. Reason: post pics/add info |
#2
|
|||
|
|||
Good looking knife for your 3rd. Keep at it . Take closer pics next time.
|
#3
|
|||
|
|||
Very nice. I like the two tone handle. I'll have to try that.
Andy __________________ "AN EXPERT IS A MAN WHO HAS MADE ALL THE MISTAKES WHICH CAN BE MADE IN A VERY NARROW FIELD." -NIELS BOHR |
#4
|
|||
|
|||
Thanks for the replies and the kind words...I am trying to figure out how to post larger pics on here. If I size them too big I can't post and these are a little too small so I'll get it right eventually.
|
#5
|
||||
|
||||
Looks like you did a great job on that handle. Very attractive. Keep up the good work.
Shane |
#6
|
|||
|
|||
Nice knife. It is amazing how some knives are made and others "evolve" due to changes in design (We never make mistakes. We just do redesigns during construction.)
Gary Biggers |
Tags |
blade, knife, knives |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|