|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Heat Treating and Metallurgy Discussion of heat treatment and metallurgy in knife making. |
 |
|
|
Thread Tools | Display Modes |
|
#1
12-06-2009, 07:31 PM
|
|||
|
|||
|
Forge ??
I am looking to build a simple firebrick forge using a modified sidearm burner from Larry Zoeller. I am going to build one similar to the one on Larry's website. I already have the firebrick, regulator, guage, and propane lines. I attached a picture of what I have. My question is will I need any additional fittings to hook to the burner, or is what I have sufficient? Thanks.
 
|
|
#2
12-07-2009, 06:30 AM
|
||||
|
||||
|
Not much there to go on. I would recommend a quick, 90 degree shutoff valve at the tank connection. Screwing around with a multiturn valve while gas is leaking or flames are leaping is not smart.
Check all your connections with soapy water prior to lighting up. __________________ Carl Rechsteiner, Bladesmith Georgia Custom Knifemakers Guild, Charter Member Knifemakers Guild, voting member Registered Master Artist - GA Council for the Arts C Rex Custom Knives Blade Show Table 6-H
|
|
| Tags |
| forge |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
