|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Paragon Kiln
I realize this is a top load kiln, but I'm wondering if this is a good deal?
Any advice would be appreciated. Mark http://missoula.craigslist.org/art/4491660144.html |
#2
|
||||
|
||||
Its cheap enough to be worth the risk. Its a top loader which is not the easiest thing to use but it will work if you can rig a way to hold your blades. Anyway, not much around that can compete with that price.
You probably should try to get that pyrometer too since there is no programmable control on that kiln ... |
#3
|
|||
|
|||
couldn't you jus lay it on its side and use a ceramic piece on bottom to keep your blades off of the coils
|
Tags |
advice, art, blades |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Paragon kiln problem | SVanderkolff | Tool Time | 2 | 12-27-2012 12:54 PM |
paragon kiln in Florida on ebay | NJStricker | The Supply Center | 1 | 04-11-2007 04:01 PM |
Paragon kiln | NJStricker | Knife Making Discussions | 5 | 02-07-2007 07:12 AM |
Argon atmosphere/Paragon kiln | BillFoote | Heat Treating and Metallurgy | 1 | 04-19-2005 09:25 AM |