|
|
Tool Time Let's talk shop. Equipment, Tips & Tricks, Safety issues - Post it here. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
KMG Power source?
KMG 10 is ordered now waiting on shipping, now to find the motor I wish to use. I found a Leeson TEFC 2 horse 110/220 single phase for $125 (he'd take less) with a 7/8ths shaft (I think didn't write down the model number) I just ordered the 3/4 drivestep pulley for the grinder and'll use a standard pulley on one of my random 1hp motors. But I can run it until I find a motor off of my pillow block assembly.
My question is what horsepower rating should I go with? Rob sells Leeson motors on his site, but the one I found in a shop isn't on the site. If I do buy a new motor wha brand should I go with? Leeson, Baldor, GE? What shaft size should I find? 5/8ths or 3/4? and my final most trivial question is what type of stand should I build for it? |
Tags |
baldor, beaumont metalworks, block, brand, build, kmg 10, leeson |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Anidizer power source? | Will | Tool Time | 2 | 06-05-2003 10:04 AM |
Power hammers | Bob Brothers | Tool Time | 7 | 12-04-2001 07:53 PM |
Power hammer | BCB27 | Tool Time | 1 | 07-07-2001 07:46 AM |
power hammer | justin time 1 | Tool Time | 2 | 01-15-2001 07:02 AM |