|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
| The Newbies Arena Are you new to knife making? Here is all the help you will need. |
 |
|
|
Thread Tools | Display Modes |
|
#1
10-02-2013, 02:19 PM
|
|||
|
|||
|
Re-heat treat?
I came across a couple of ATS-34 blades I profiled a long time ago. I took one of my little chain saw files and ran it across the edge of the spine and it caught and scraped a bit of metal off. I suspect the blades are not heat treated, but I'm not one hundred percent sure. Is there any danger of ruining the blades by putting them through the entire heat treat process again even if they have already been heat treated in the past?
Jim T 
|
|
#2
10-02-2013, 04:17 PM
|
||||
|
||||
|
If they're too soft what do you have to lose? Just make sure it is not decarb first.
Austin __________________ Austin Colvin
|
|
| Tags |
| ats-34, bee, blade, blades, chain, edge, files, heat, heat treat, make, metal |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone able to heat treat ats-34? | nutball | The North Carolina Custom Knifemakers Guild Forum | 1 | 11-21-2012 06:33 PM |
| First Heat Treat Done | Bowman | The Newbies Arena | 21 | 10-07-2012 10:10 AM |
| Re-Heat Treat? | mrgantz | Heat Treating and Metallurgy | 4 | 02-12-2010 03:42 AM |
| Heat treat? | ranger1 | Heat Treating and Metallurgy | 6 | 01-21-2007 09:54 AM |
| Heat treat set up. | Ray Cover Jr | The Newbies Arena | 5 | 04-16-2004 04:14 AM |
Linear Mode
