|
|
Knife Kits Forum New to the art of knife making? Learn to make awesome knives, using advanced hands-on training inside. From KnifeKits.com. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Is it a good deal?
There is a used about 20 years old Wilton Drill Press Model 2350 for sale
at $50. It's rusted but seems to be OK. Is it a good buy? Is there something specific I need to check for before buying? here is some specs: Drilling Capacity Cast Iron .................................................. . Up to 5/8 In Steel .................................................. ....... Up to 1/2 In Drill to Center ................................................. 15 Inches Motor Rating .................................................. ..... 1/2 hp, 1-Phase . RPM............................................... ........... 1725 Pre-wired Voltage ...................................... 115 V Column Diameter .......................................... 2-7/8 In. Quill Diameter .................................................. . 1-7/8 In. Travel .................................................. ...... 3-3/8 In. Table Overall .................................................. .... 10 x 10 In. 16-1/2 In. Working Surface ....................................... 10 x 10 In. Travel .................................................. ...... 32-3/8 In. Base Size .................................................. ........ 11 x 19-1/2 In. 17-3/4 In. Working Surface ....................................... 10 x 10 Chuck Size .................................................. .. 5/8-In., Key Ch Overall Dimensions Length .................................................. ..... 26 In. Width .................................................. ...... 13-3/8 In. Height .................................................. ..... 63-1/2 In. Spindle to Table (Max.) ................................... 32-3/8 In. 3/8 In. Spindle to Column (Max.) .............................. 10-7/16 In. 7/16 In. Spindle To Base .................................................. ... 48-3/4 Taper .................................................. ....... MT-2 RPM (12 Speeds) .................................... 250, 340, 390, .....3100 |
#2
|
||||
|
||||
Hello,
If you want old iron like this the drill press is a good deal. I just go to harbor freight and buy one of there 39.00 press's. They work fine for meand they are new. I have 6 of them in the shop. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|