|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Folders : washers, relief milling, and bearing)s ... oh, my!
Once again, I am getting myself confused by inputting too much information from divers sources.
In some circumstances I am seeing people milling some relief on folders around where the tang would be. In others I see a bigger hole put in the pivot and a bushing put in it. And in yet some others, I am seeing 0.005 washers put in on either side of the blade. Yet others may even suggest combining these things. And even others suggesting that these things make no difference. Is it just adding specific specific value to the final product? I saw something that suggested it prevented scratches from appearing on the ricasso or some such thing. So the question is, is this necessary? If so, which is the best bang for the buck? Any clarification or suggestions. |
Tags |
bearing, blade, buck, build, building, ca, degrees, design, folder, folding, hardware, how to, knife, knifemaking, knives, make, pivot, question, relief, tang, tools, washers |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Recess for pivot washers in folders - End mill? | Rasmus Kristens | The Newbies Arena | 14 | 09-22-2017 07:05 PM |
Relief by Montejano | Montejano | Fine Embellishment | 1 | 03-02-2014 03:35 PM |
What size of washers do you use on liner locking folders? | Frank Niro | The Folding Knife (& Switchblade) Forum | 12 | 06-23-2009 06:27 PM |
New Jim Small relief carving | Don Cowles | Fine Embellishment | 5 | 01-13-2006 06:49 PM |
basket weave relief | tmickley | The Sheath/Holster Makers Forum | 7 | 05-22-2002 12:08 AM |