|
|
Tool Time Let's talk shop. Equipment, Tips & Tricks, Safety issues - Post it here. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
little BLACK blade vise
I know this is no new design but it works great for finish work another photo after paint and being mounted.
|
#2
|
||||
|
||||
Good job. It looks a lot like mine. I also used the nut screw and even the piece of allan wrench for the handle. Yours is way better than mine though. I made mine just good enough to function.
|
#3
|
|||
|
|||
Thanks Icho it has been a very welcome addition , I like that I can turn the work piece to face in towards the table so no one will walk by and catch an arm on the blade!
|
#4
|
||||
|
||||
For sure. I also rotate mine for safety. For such a simple thing it is so handy.
|
#5
|
|||
|
|||
i use square tubing
I then put in two hockey pucks to hold the blade...........does great...........Either way its a great tool..........carl
__________________ carl |
#6
|
|||
|
|||
looks nice
|
#7
|
|||
|
|||
Vise
What is the center material that holds the blade?
Thanks in advance Loggerhead |
#8
|
|||
|
|||
It"s a 2"diameter 6" long piece of Acetal Plastic "Delrin" I took out a 1/4" wafer from the center...
|
#9
|
|||
|
|||
do you have a set of plams for this vise??? neil
|
Tags |
bee, blade, grinder, handle, knife, knives, made, material, plastic, simple, vise |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Folder Blade Pin Vise Prototype | cnccutter | The Folding Knife (& Switchblade) Forum | 2 | 09-03-2012 11:46 AM |
Black blade by ST | trentinistefano | SBC Forum (Sociedade Brasileira de Cuteleiros) | 14 | 02-07-2008 03:01 PM |
Black blade by ST | trentinistefano | The Display Case | 6 | 02-02-2008 11:50 PM |