|
|
The Sheath/Holster Makers Forum This is the place to discuss all forms of sheath and holster making. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Trying to locate unique sheath design seen here....
Hi KN-ers,
Thanks for all the help. I am trying to locate the post of a great sheath design. It was almost a friction-fit, but had a small flap that wrapped around (to the user's front) the very butt-end and snapped to the center of the sheath with a nice snap. It had the ease-of-use of a friction sheath, but also the surety that the knife could not bounce out. Does anyone know of the maker? Thanks very much. |
#2
|
||||
|
||||
What type of blade did it hold. That would help?
__________________ Stephen Vanderkolff Please come on over and check out my website. http://www.vanderkolffknives.com/ Thanks |
#3
|
||||
|
||||
Thanks SV,
It seemed a straight-forward hunting blade, not a bowie-style or more stylized model. Thanks again. Orion |
#4
|
||||
|
||||
Description is a bit difficult to cypher, so probably hard to describe from your side as well. Did you try going back through the old post to see if you could spot it?
__________________ Carl Rechsteiner, Bladesmith Georgia Custom Knifemakers Guild, Charter Member Knifemakers Guild, voting member Registered Master Artist - GA Council for the Arts C Rex Custom Knives Blade Show Table 6-H |
Tags |
back, blade, bowie, design, holster, hunting, knife, leather, leather die, leather tooling, post, sheath, tanning |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Vintage Model 14's | Jacknola | Randall Knives Forum | 157 | 07-06-2020 09:38 PM |
sheath design | EdStreet | The Sheath/Holster Makers Forum | 12 | 11-14-2006 04:56 PM |
Unique Sheath | hammerdownnow | The Outpost | 3 | 04-18-2005 12:36 PM |
Help with sheath design | Bob Sigmon | The Sheath/Holster Makers Forum | 17 | 12-02-2002 08:13 PM |