|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Fit & Finish Fit and Finish = the difference in "good art" and "fine art." Join in, as we discuss the fine art of finish and embellishment. |
 |
|
|
Thread Tools | Display Modes |
|
#1
05-27-2010, 05:29 PM
|
||||
|
||||
|
Timascus warpage
Junko is finishing a little folder off and she flame colored the Timascus. Afterwards, we discovered that the bolster had warped so now when the knife is assembled, it will pull the liner shifting blade position as well as opening and closing is not smooth. The warpage is about 1/64'th. Not a lot but if she flattens the bolster, it will then shift the dovetail contact for the handle scale.
Thoughts on how to remedy this? __________________ Mike  
|
|
| Tags |
| blade, folder, knife |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Heat treat with salts better as far as warpage.. | SPryor | Knife Making Discussions | 15 | 07-20-2007 09:40 AM |
| Blade Warpage | rasp181 | The Newbies Arena | 1 | 05-18-2007 06:25 PM |
| Blade warpage while heating? | Ice Tigre | Heat Treating and Metallurgy | 4 | 03-22-2005 10:33 PM |
| Preventing warpage in heat treat | Jason Cutter | High-Performance Blades | 21 | 12-16-2002 07:45 PM |
| Timascus | Tom Ferry | The Supply Center | 3 | 05-03-2002 01:31 PM |
Linear Mode
