|
|
The Sheath/Holster Makers Forum This is the place to discuss all forms of sheath and holster making. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
How can a sheathmaker expose in knives show?
The title includes my whole question.
I want to know how a sheathmaker, not a knifemaker can participate in any knives show. Could you tell me your experience about that? Thanks a lot. |
#2
|
||||
|
||||
I would think if you paid for a table the promoters would not mind as sheaths are knife related
as a knifemaker who doesn't like leatherwork as much as blades I would welcome the chance to meet some sheathmakers |
#3
|
|||
|
|||
You can also attend knifemaking hammer in's. There's a very good sheath maker that comes to the one here. I would think a knife maker is more inclined to purchase a sheath before a end user, at least a nice one. A good sheath can sell a knife, I learned that from experience.
|
#4
|
|||
|
|||
All the show that I've attended allow anything knife related to be shown and even that's not necessarily strictly enforced. I went to a show down near St. Louis and a man was showing turned bowls along with his knives. If you pay for you table you should be fine.
Doug __________________ If you're not making mistakes then you're not trying hard enough |
#5
|
||||
|
||||
Thanks a lot for your answers!
|
#6
|
||||
|
||||
Pancho, you thinking about coming to the States for a few shows or just asking in general?
I've not been to any shows where good sheath makers were not allowed (even some not so good). If you are coming to the States for shows, be sure to post which ones and when. You have a lot of makers here on KNF that'd like to greet and meet you. __________________ Carl Rechsteiner, Bladesmith Georgia Custom Knifemakers Guild, Charter Member Knifemakers Guild, voting member Registered Master Artist - GA Council for the Arts C Rex Custom Knives Blade Show Table 6-H |
Tags |
bee, blades, hammer, holster, knife, knifemaker, knifemaking, knives, leather, leather die, leather tooling, man, post, sheath, sheaths, tanning |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Sheathmaker | Don Robinson | The Sheath/Holster Makers Forum | 4 | 08-31-2006 10:18 PM |
Sheathmaker, where are you? | Don Robinson | The Sheath/Holster Makers Forum | 42 | 05-16-2006 01:43 PM |
Looking for a sheathmaker | T-Wolf | The Sheath/Holster Makers Forum | 7 | 03-07-2006 01:07 AM |
My Sheathmaker | Steve | The S.R. "Steve" Johnson Forum | 0 | 05-11-2005 08:36 PM |
Excellent expose on the Taliban | dogman | Knife Making Discussions | 1 | 09-17-2001 10:59 PM |