|
|
Fit & Finish Fit and Finish = the difference in "good art" and "fine art." Join in, as we discuss the fine art of finish and embellishment. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
looking for someone to engrave
Would like to do a knife with some engraving on the SS bolsters, was hoping that someone here might know of an engraver who I could send the knife or bolsters to, and what it may cost to do, flower or vine design would be nice, of course so would a bear, dear, trout, bass, well you know.
Thanks Carl |
#2
|
|||
|
|||
Easy Carl, Damon. Should be in Ray's chat room tonight.
|
#3
|
|||
|
|||
You can look through here and get some ideas. ...
https://www.flickr.com/photos/oiseaumetalarts/ then contact through PM and we can fine tune the details from there. |
#4
|
|||
|
|||
Thanks Jim, Damon I will pm you in April as I hope to have the knife finished, your work is excellent.
Carl |
Tags |
bolsters, design, easy, engraver, engraving, knife, vine |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
When to engrave | AKHammonds | Fine Embellishment | 3 | 06-13-2010 02:18 AM |
How to engrave steel | dzucherato | Fine Embellishment | 3 | 11-29-2006 12:16 PM |
Folder to Engrave | banjo_art | Fine Embellishment | 4 | 07-08-2006 04:40 PM |
To engrave or not to engrave? | SVanderkolff | The Display Case | 9 | 01-08-2005 12:03 PM |
learn how to engrave | ron p. nott | Fine Embellishment | 5 | 07-07-2002 10:30 AM |