|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Tool Time Let's talk shop. Equipment, Tips & Tricks, Safety issues - Post it here. |
 |
|
|
Thread Tools | Display Modes |
|
#1
07-15-2023, 11:26 AM
|
|||
|
|||
|
is there any hope for this grinder?
  i inherited this grinder from my father and was hoping to use it for knife making. I can grind the bevel on one side of the blade but the switch and motor get in the way when working on the other side. I'd like to put a table on the front of the grinder but have no idea if this is possible or where to start with it. Any help is appreciated! 
|
|
#2
07-15-2023, 03:19 PM
|
||||
|
||||
|
Welcome!
Always hope and a way to adapt this into a machine that you can use. Sometimes it may takes some $ so depends what level of an investment you may be willing to undertake. Can change the position of contact and other wheels, make up a different base to mount this on and so on. Using pulleys mounting a motor off this base will open up that one contact wheel. As this is configured it will do flat grinds too. In search I found this place looking for various parts that can be adapted: https://originblademaker.com/product...rinder-wheels/ They have a variety of parts that can be used in a conversion. __________________ Mike  
|
|
| Tags |
| a, art, base, belt, bevel, blade, ca, conversion, flat, grinder, knife, knife making, make, making, motor, mount, switch, wheels |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Damascus...Hope you like it. | jtippy | The Display Case | 0 | 07-26-2009 04:51 PM |
| There is hope!! | Steve | The S.R. "Steve" Johnson Forum | 4 | 03-10-2007 03:40 PM |
| I done did it.. I hope it is right. | Fsawyer | Knife Network Community | 9 | 02-08-2005 12:20 PM |
| Hope this works | Steve Vanderkolff | The Display Case | 1 | 01-17-2002 08:38 PM |
| Hope you can help | Redcharlie | Knife Collecting | 5 | 01-10-2002 02:08 PM |
Linear Mode
