forged 1080,buckeye burl, and wrought iron

[atakach]

This one is made from a blade i forged out of 1080.

It's been fully flat ground, and edge hardened. The blade has a satin finish, and the fittings were deeply etched and lightly buffed off to a satin finish.

The handle is stabilized buckeye burl, and the tang sets about 3"+ into the handle, and is pinned internally,as well as being filled solid with epoxy.

The wrought iron in this guard has a lot of grain, more than in most iv'e used.

The o.a.l of knife is 11 1/4'', the blade is 6 1/2 long from tip to plunge cut, and 1 7/16'' at the widest

The spine is a little over 1/8'' at the guard, and tapers toward the tip so it's
little light to go chop a cord of wood with, but a solid built knife none the
less.


Price is $340 shipped , with sheath and zipper case. First i'll take get's it!!

You have your choice of left or right carry, and choice of available dyes for the sheath.








thanks for looking,
andrew takach

[p moore]

That is a beauty, good luck.

[atakach]

thanks p moore

andrew