|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Ed Caffrey's Workshop Talk to Ed Caffrey ... The Montana Bladesmith! Tips, tricks and more from an ABS Mastersmith. |
|
|
Thread Tools | Display Modes |
|
#1
06-02-2014, 05:46 PM
|
|||
|
|||
|
Little Bird and Trout
A few of the others I've been working on took a turn for the worse....due to operator error... So, to make myself feel better, I started this one a little bit ago. I had some bigger pieces of 15n20 laying around and decided to cut a knife out a while back. It was sitting there, so I decided to get to grinding on it. Somehow, I didn't completely mess it up, though I wish I did better on the plunges and a few other things. This knife is pretty thin and has a fair amount of flex to it. With it being so thin and all the extra holes I drilled in the tang, it's super light.
    Took it to a nice 600 grit finish, no j-hooks or anything, for once. Picked out a piece of African Blackwood with some figure to it that I think will look nice on it. Still a little ways to go, but might actually hit the finish line with this one. Jeremy 
|
| Tags |
| antler, art, back, bee, blade, bone, drill, epoxy, flat, folder, grinding, hammer, john, knife, knives, make, making, pins, press, project, scales, steel, supply, tang, video |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bird & Trout | Don Cowles | The Display Case | 12 | 04-14-2005 07:33 PM |
| Bird & Trout | SKIVIE | The Display Case | 16 | 11-08-2004 02:40 PM |
| Bird & Trout | Terry Primos | The Display Case | 7 | 09-01-2004 02:55 PM |
Threaded Mode