|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
|
Thread Tools | Display Modes |
|
#1
05-13-2017, 07:53 PM
|
|||
|
|||
|
cracked me up
So I was foolish and tried edge quenching file steel in water....4 sec in ping,ping,ping.
water wasn't hot enough....heat may have been off on the spine I dunno. edge tried to separate from the spine. First time I've done this and it wasn't a waste. just disappointed because it was going well. __________________ Do not go gentle into that good night, Old age should burn and rave at close of day; Rage, rage against the dying of the light. -Dylan thomas 
|
| Tags |
| art, back, bee, blade, craft, edge, file, first time, forge, grinder, hand, heat, hot, japan, japanese, knife, knives, make, material, post, steel, teach, video, water |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cracked sheath | donnymac250 | The Sheath/Holster Makers Forum | 10 | 11-29-2014 09:46 PM |
| More cracked 5160 | grant | Ed Caffrey's Workshop | 6 | 11-01-2012 06:53 AM |
| Cracked Spine | Ed Tipton | Heat Treating and Metallurgy | 3 | 07-31-2010 06:15 AM |
| possible cracked blade | J. Doyle | Ed Caffrey's Workshop | 5 | 06-13-2010 01:08 AM |
| cracked blade | terence | The Newbies Arena | 5 | 12-06-2008 08:52 AM |
Threaded Mode