|
|
The Supply Center What's Hot ... and where the deals are! Supplies are our specialty ... |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
1 3/4" round 5160
I've got two springs of 5160 with 1 and 3/4" coils.
They are brand new. They're BIG. Imagine what you could get out of 1 3/4" round when forged to the dimension of your choosing. Calculator says these weigh 300 pounds. Lots of steel these days goes for 3-4-5 dollars a pound. I'll sell these BOTH for 2 bucks a pound. I know where they came from. I know who made them. They were off spec for their designed application and were scrapped. (They were actually designed for the springs in the bottom of hydraulic cylinders!) I will only list these for a few weeks. Then, I'm going to do something else with them. (That picture was taken about 8 years ago. The springs are a little rusty now. I'm heavier - the springs are not.) __________________ Blade Show Table 8-Q What do you do when you see your ex in pain, limping and bleeding? Relax. Take a deep breath. Reload and then shoot again. http://www.andersenforge.com/ |
#2
|
|||
|
|||
Very tempting, but I'd imagine the shipping to Montana would be cost-prohibitive. But I guess I wouldn't need to buy more 5160 for a looooooong time.
|
Tags |
brand, forged, made, steel |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2" round, titanium stock. | Jerry Bennett | General ::: Items and Bargains | 0 | 09-29-2008 12:26 PM |
black linen and 5160 round bar, makes a big fun knife | MPMetal | The Display Case | 7 | 10-12-2005 02:29 PM |
3/4" round bar of 5160 and 52100 (NEW) | raker | General ::: Items and Bargains | 2 | 07-01-2005 08:50 PM |
2" round stock | william | Tool Time | 1 | 04-05-2004 01:05 PM |
5" Round Anvil | EMU | The Outpost | 16 | 04-29-2003 05:56 PM |