![]() |
![]() |
![]() |
|
![]() |
![]() |
||
![]() |
![]() |
|
![]() |
|
Tool Time Let's talk shop. Equipment, Tips & Tricks, Safety issues - Post it here. |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Finding a maker's mark stamp company
Hi All
I'm looking for advice on the best company to craft my makers mark for me, since I don't have the equipment or steady hands required to do it myself. The stamp design needs to be 5/16" tall with three very tiny letters on it and hard enough to stamp the 1095 I'm working with. Any help would be greatly appreciated. Thanks in advance. |
#2
|
|||
|
|||
A maker's mark for stamping annealed steel is kind of expensive, but I know Damon a maker and engraver, I think he makes them. He's a contributor here. You can see his work and contact him by clicking on the envelope on Flickr.
https://www.flickr.com/photos/oiseau...th/8372335316/ |
#3
|
|||
|
|||
Hey thanks, I will take a look. I appreciate it a lot.
|
#4
|
||||
|
||||
Why not etch it?
|
#5
|
||||
|
||||
Contact Ernie for a custom stencil:
http://www.erniesknives.com/knifemaker_stencil.html Build your own etcher or buy one from Ebay (some herein might even be willing to make and sell you one on request). __________________ Andy Garrett https://www.facebook.com/GarrettKnives?ref=hl Charter Member - Kansas Custom Knifemaker's Association www.kansasknives.org "Drawing your knife from its sheath and using it in the presence of others should be an event complete with oos, ahhs, and questions." |
#6
|
||||
|
||||
If you havent already found a supplier, I would suggest Buckeye Engraving, I had a great experience with them. Plan on about $100 shipped. Wonderful product. Use a hydraulic press instead of a hammer- the stamp will last a good 30-50 years!
http://www.buckeyeengraving.com __________________ AT "We shall walk with a walk that is measured and slow, And watch where the chalk-white arrows go To the place where the sidewalk ends." Shel Silverstein |
![]() |
Tags |
1095, advice, buy, craft, custom, design, engraver, engraving, etch, hammer, hydraulic press, knifemaker, maker's mark, makers, press, sell, steel, stencil, tiny |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Knife Maker's Stamp | kvistads | The Newbies Arena | 4 | 01-25-2009 04:45 PM |
Where Do You Guys Put Your Maker's Stamp? | Rawhide Leather | The Sheath/Holster Makers Forum | 5 | 01-30-2008 05:35 PM |
Maker's mark | Drac | Knife Making Discussions | 18 | 09-29-2003 06:49 PM |
Leather Maker's stamp from Max | MtMike | The Outpost | 6 | 08-08-2003 02:28 PM |
Anyone recognize this maker's stamp? | Buddy Thomason | Knife Making Discussions | 0 | 07-11-2003 05:11 PM |