|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
| High-Performance Blades Sharing ideas for getting the most out of our steel. |
 |
|
|
Thread Tools | Display Modes |
|
#1
11-30-2012, 01:37 PM
|
|||
|
|||
|
brass
I have two large brass spools . I understand they were used in the neck of a large valve
Not having a way or the knowledge to melt them down to a useable form. I would like to trade them for smoothing I can use. I was thinking about some Damascus that could be heat treated like 5160 . but I am open to suggestions. let me know if any one is interested and I will get pictures and weight. Thanks 
|
|
| Tags |
| 5160, brass, damascus |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Brass liners | JawJacker | The Newbies Arena | 7 | 11-20-2012 09:18 PM |
| Found an old looking all brass folding knife with a brass blade, information? | rx7rotary13b | Knife Network Community | 2 | 02-10-2012 11:17 PM |
| Burlap and brass | Joel | The Display Case | 15 | 05-01-2007 04:19 AM |
| brass rod test | Omega | The Newbies Arena | 3 | 04-01-2003 06:03 PM |
| brass | 5Trey5 | The Newbies Arena | 1 | 05-25-2001 06:10 PM |
Linear Mode
