My first 3 Damascus knives
Hi, I'm new to the forum, and to knife making. This is my first post. Thought I would post a pic of the first 3 Damascus knives I made. These are the 4'th and 5'th knives I have ever made. The two matching knives I made for my parents, and they are made from 1084,1095, and 15N20. They are 64 layers with some raindrop pattern in them. The other knife is 1095, and 15N20, and is only 24 layers. Handles are Cocobolo. The handles on the two matching knives have a partially hidden guard that I came up with as a way to fix a mistake I made. I drilled the forward tang hole too close to the guard and it would have left less than 1/4" of wood if I butted the wood up against the guard. I was afraid that would crack over time, so I wrapped the wood around the guard by cutting it out in a mill. All together I have about 70 hours in the two matching knives. Those two knives were made from the same piece of steel, and the handle scales were all four cut from one piece of wood, then one scale from each pair was used on each knife so they are truly matching knives. I tried to make a cross pattern with the raindrop pattern, but didn't come out the way I planned, so they are hard to see. Hope you like them. Any constructive criticism is welcome as I am learning. I started making knives in September. Thanks for looking!
Last edited by DamascusFreek; 06-27-2018 at 01:49 AM.
|