|
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
Tool Time Let's talk shop. Equipment, Tips & Tricks, Safety issues - Post it here. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
KBAC drive help
I finally broke down and bought the KBAC27D controller for my new motor. It seems to run good but its running in reverse. I didnt buy the reverse switch. Dont see anywhere there is a reverse jumper in manual. Any clues ?
thanks Dave |
#2
|
||||
|
||||
Just a clue because I have no direct experience with that controller but - if there is an option for a reverse switch as you indicated then that means there are wires in there somewhere that can be reconnected to reverse the motor's direction. My guess would be that the wire you are looking for is not currently connected to anything. If all wires are connected then there will be two that need to be reversed ....
Last edited by Ray Rogers; 04-17-2010 at 04:08 PM. |
#3
|
||||
|
||||
I just hooked it up like the old controller. When i looked at wiring on BMW site I saw I had two wires backwards. So when i flipped them..runs correctly
Thanks Ray Dave |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
KBAC-27D Output values | ShaneMinnear | The Newbies Arena | 12 | 01-26-2013 01:03 PM |
Donation Drive with 6 EDC being put up | delander | Factory Knife & Mid-Tech Discussion | 1 | 09-04-2005 11:10 PM |
looking for a drive wheel | tmiller5087 | Tool Time | 9 | 05-07-2004 11:17 AM |
The creative drive | Misternatural? | The Outpost | 39 | 07-09-2003 12:50 PM |
Drive in the country! | MongoForge | The Outpost | 2 | 09-29-2002 09:54 AM |