|
|
Heat Treating and Metallurgy Discussion of heat treatment and metallurgy in knife making. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
154 CM now, help
I ordered from K&G 1 inch wide CPM steel, precision ground which I have been using. They sent, instead, 154CM, Mill run and I am not sure of a couple of things. First the heat treat, second how to take care of the mill run part. Help would certainly be appreciated.
|
#2
|
||||
|
||||
If your original order was CPM154 it heat treats the same. Here's the spec sheet -
http://www.crucibleservice.com/datas...TOKEN=29068058 I use a 12" disc grinder to remove scale. Jim __________________ I cook with a flair for the dramatic, and depraved indifference to calories |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|